Beta, Cushion, Loop, Gang or Twin Clamps? Which Tube Clamp to Use

Stainless steel gang clamp for four 1/4 inch OD tubes

A-Best Industrial Inc. Fittings, Valves, and Tubing |

A tubing run can have perfect fittings and still leak in a year if nothing is holding it. Tubing that hangs on its own weight, rubs on steel or shakes with a pump works its fittings loose. The fix is the right clamp in the right place, and the right clamp depends on how many lines you're running and what you're mounting to.

Beta clamps: the instrument tubing standard

Beta clamps are our most popular clamp for instrument tubing. The split polypropylene body cradles the tube, keeps it off bare metal and dampens vibration. The strut mount version drops into standard strut channel with no welding, in sizes from 1/4" to 2" tube and 1/8" to 2" pipe. If you'd rather weld to your steel, start with a beta clamp weld plate.

Strut mount beta clamp with stainless steel hardware

Cushion and loop clamps: one line, low profile

For a single line along a wall, frame or skid, a cushion clamp or loop clamp (P-clamp) is the simple answer. The cushion keeps metal off metal and soaks up vibration.

Stainless steel loop clamp with cushion for 1/2 inch tube

Gang clamps: neat bundles of parallel lines

When several lines run side by side, such as impulse lines to a transmitter rack or tubing across an analyzer panel, gang clamps keep them evenly spaced in one neat bundle. Our stainless steel gang clamps hold 2 to 8 tubes of 1/4", 3/8" or 1/2" OD and come in bags of 25, with matching stainless bolt kits in bags of 50.

Twin series clamps: two lines, welded down

Twin series clamps hold two lines of the same size side by side in one body, welded to your support steel. They come complete with stainless or carbon steel hardware, and we stock replacement bodies, weld plates and cover plates.

Twin series weld-on tube clamp with stainless steel hardware

Stainless or zinc-plated hardware?

  • Stainless steel: outdoor, coastal, washdown and corrosive process areas. If your stainless tubing runs out in the weather, match it with stainless clamp hardware.
  • Zinc-plated: indoor, dry areas and general plant use.

Where to put the clamps

  • Follow your site spec or the tubing manufacturer's support spacing.
  • Put a support close to every valve, gauge and heavy component, so the fitting doesn't carry the weight.
  • Support both sides of a bend and both sides of a tube fitting on long runs.
  • Never let tubing rest on another pipe or a sharp edge.
  • Don't overtighten. A clamp should hold the tube firmly without crushing it or the cushion.

Check the joints while you're there

If you're adding clamps to a run that's been shaking, the fittings may have taken a beating. With the line pressurized per your site procedure, apply Gator Leak Detector around each fitting near the clamps and watch for bubbles or foam. If something leaks, isolate and depressurize before you put a wrench on it. Never tighten a fitting under pressure.

Not sure which clamp or size?

Tell us your tube or pipe size, how many lines and where they run, and A-Best Industrial Inc. Fittings, Valves, and Tubing will help you pick. See all tube clamps, call 310-833-3353 or email sales@abesttube.com.