PTFE-Lined Braided Hose or Rubber Hose? How to Choose

Two rubber hydraulic hose assemblies

A-Best Industrial Inc. Fittings, Valves, and Tubing |

When a hose fails early, the cause is often not pressure. It's the wrong liner for the media. A rubber hose that's perfect for hydraulic oil can swell, harden or crack in a solvent line. Here's how to decide between rubber hose and a PTFE-lined stainless braided hose before you order.

Rubber hydraulic hose: built for oil

Our hydraulic hose is US Coast Guard approved and built in our San Pedro shop, usually while you wait. The 2-wire braid compact hose handles hydraulic oils from -40°F to +212°F, and the 4-spiral hose covers the high-pressure circuits on cranes and heavy equipment. For trucks, forklifts, cranes and most mobile hydraulics, rubber hose is the right call: it's flexible, tough and easy to replace.

Where rubber struggles is anything it wasn't compounded for: aggressive chemicals and solvents, steam and very hot media, and clean or sample gas lines where the hose shouldn't add anything to what flows through it.

PTFE-lined braided hose: one liner, many media

A PTFE (Teflon) lined stainless braided hose puts a PTFE liner inside a stainless steel braid.

  • Chemical resistance: PTFE resists almost all chemicals and solvents, so one hose can handle many different media.
  • Clean bore: the smooth, non-stick liner resists buildup and is easy to flush and purge.
  • Temperature: PTFE handles high heat and cold better than rubber, for steam, hot oil and chemical lines.
  • Strength: the stainless braid adds pressure strength and protects the liner from abrasion.

Stainless steel braided hose

Where PTFE-lined hose makes sense

  • Chemical transfer and process lines
  • Analyzer, sample and calibration gas lines, including stack testing sampling systems
  • Steam and hot oil
  • Paint, adhesive and solvent lines
  • Lab and instrument connections

When all-metal hose is the answer

For temperatures or media beyond what a PTFE liner should see, an all-metal stainless braided hose is the next step up. We build those at our off-site facility.

Handle PTFE hose with care

  • Respect the minimum bend radius. Kinking a PTFE liner can crack it, and you won't see the damage under the braid.
  • Don't twist the hose when you tighten the ends. Hold the hose end with a backup wrench.
  • Support long runs so the weight isn't hanging on the end fittings.
  • Bring us the old hose if you're replacing one. We'll match the length and ends.

After installation, pressurize per your site procedure and apply Gator Leak Detector around both end connections, including any pipe-thread adapters, and watch for bubbles or foam. If something leaks, isolate and depressurize before you put a wrench on it. Never tighten a fitting under pressure.

What we need to quote

Tell us the media, working pressure, temperature, hose ID, overall length and both end connections. We stock DK-Lok tube fittings and adapters, so the hose, adapters and valves can all come from one place.

Ready to order?

A-Best Industrial Inc. Fittings, Valves, and Tubing builds stainless braided PTFE hose in our shop at 1911 N. Gaffey Street, Suite D, San Pedro. Orders ship the same day we receive your PO. Call 310-833-3353 or email sales@abesttube.com.