Wall thickness sets your tubing's pressure rating, how well the ferrules grip, and how hard the tube is to cut and bend. Here's how to pick the right wall for...
A-Best Industrial Inc. Fittings, Valves, and Tubing |
Pre-swaging sets your nuts and ferrules in a tool instead of the fitting body. Here's when it pays off on tight spots, larger tube sizes and expensive components, and how...
A-Best Industrial Inc. Fittings, Valves, and Tubing |
Many tubing leaks start with how the run was laid out and held in place, not at the fitting. Here's how to plan, bend, slope and support instrument tubing so...
A-Best Industrial Inc. Fittings, Valves, and Tubing |
Compression tube fittings can usually be disassembled and remade, but rushing it causes leaks. Here's how to depressurize safely, inspect the parts, and remake the connection right.
A-Best Industrial Inc. Fittings, Valves, and Tubing |
Clean bends mean fewer fittings and fewer leak points. Here is how to pick the right bender, measure and mark, allow for spring-back, and inspect every bend on stainless instrument...
A-Best Industrial Inc. Fittings, Valves, and Tubing |
Most fitting leaks start at the tube end. Here's how to cut, deburr and check stainless tubing so your compression fittings seal the first time.
A-Best Industrial Inc. Fittings, Valves, and Tubing |